When a company has had numerous failures with a single product, it is often not just a case of just taking the product back to the factory and ordering another batch. The worst cases of such disastrous decisions are made before the manufacturing process has even begun. This means that the manufacturing process could be over in seconds, but the end result will likely be exactly the same.

As a result, most companies have the expectation that if a new product has failed, they have two other options available. The first choice is to try and fix the problem immediately with the hope that the problem can be rectified. If that does not work, the second option is to try and find the exact cause of the failure and fix it. The problem with this approach is that sometimes the cause of the failure cannot be identified in the short-term.

An example of this is an NCC Case Solution failure. A North Carolina company discovered that one of their magnetic clamps would not open in an upright position. Because they had plenty of these clamps, they sent them out to a manufacturer to have them replaced with a new version.

However, since the problem was with the Magnetic Clamps, the manufacturer wanted to re-test it. When the test did not reveal the problem, they came back and replaced the Magnetic Clamps with a different design. Although the problem was solved, the new design was only slightly better than the old Magnetic Clamps.

NCC Case Solution was able to find that the Magnetic Clamps were problematic because the right side was too large. Unfortunately, the only way to verify that problem was by going back and re-testing the Magnetic Clamps again. This caused the company to miss a very important step.

If a company had been testing the Magnetic Clamps, they would have noticed that the clamp would rotate backwards when the sides were turned inwards. It is the turning of the clamp’s rotating parts that cause the clamp to close. To determine the cause of the problem, the company would have needed to know the turning of the Magnetic Clamps before the Magnetic Clamps went out to the factory.

NCC Case Solution had put the company on the wrong track. The company was going to have to go back and do the product testing, but in the meantime, they would not be able to fix the problem. They had tried to fix the problem during the process of product testing, but they still were not sure.

Before the company came up with the solution for the Magnetic Clamps, they realized that they had a problem with their marketing plan. Instead of just having the products developed and tested, they had learned to test and develop marketing plans. To solve this problem, they implemented a Customer Test Pilot program and a marketing plan.

The Customer Test Pilot program was done so that they could gather their data about a product by subjecting it to very high-stress testing. After the Product Development process, they decided to conduct the testing again and see what the differences were between the old and new products.

The marketing plan was used to gather ideas for their business. These ideas were then used to create an effective marketing plan for the business. A business usually has several products and services that the company offers, so the difference in each product is usually small.

What makes the case study Solution concept a valuable one is that the company, NCC Case Solution, took the time to measure the results and then looked at what the company was doing wrong. This time spent was saved, because instead of repeating the mistakes of the previous product that failed, they could simply move forward and create something better. They were able to identify the problem and the steps that they needed to take to correct it.

With the tools that case study analysis provides, a company can identify problems and then see if there is a way to fix them. Case Study Solution teaches you that when problems are in the process of solving, you should have the necessary tools and resources to solve them. before they cause another problem.

Share This